I am trying to use the Kabinet for monitoring the Aux-in Signal (as replacement for a real monitor).
Using it without the Kemper it doesn't sound good (i thought so).
Then i used to run it through the Kemper.
- Aux Signal to Monitor Output at 10.
- Monitor Output at 10
- Monitor linked to Master (not Main and not Headphones are linked)
- and then switching the Monitor from Master-Mono to Off.
it worked.
But then after unplugging the Monitor output and plugging it again, the Monitor Out Volume is at 0.
as Montor is off, i cannot access the Volume.
Using the Master Volume Knob ended in some weird behavior:
After turning it up, it turns slowly down again.
And i can hear nothing.
Did this on a Kemper Stage with OS 9.0.5.45603 Release