Yes, there is definitively some high end dropping away somewhere.
- Did you check the Output EQs in the Master section?
- Is it the same when you use the 1/4" Master outputs?
- Set clean sense so that it is orange but never red and Distortion Sense to < 0 > and turn down the Noise Gate. Then make shure the Input module is locked.
* Did you check the Output EQs in the Master section?
Output EQs in master sections should be flat?
* Is it the same when you use the 1/4" Master outputs?
You mean connecting interface/monitors using TRS cables not XLR?
Turning down the noise gate doesn't change the sound. I will play with clean and distirtion senses. How to lock input module? Does it mean that after setting proper Clean Sense and Distortion Sense locking them will cause that any other patch will previously set values?