Kemper to Interface using Jack plug

ChickenPicker · September 5, 2021 at 5:36 PM

Hi there,

Probably stupid question, but your help would be highly appreciated.

I have a Kemper profiler powered Amp and a FocusRite interface.

Using Garageband on my Mac.

With jack plug from Main Out to Input jack on interface.

Interface to Mac through Usb.

But:

I am still hearing the guitar through my speaker, although I want to hear everything through headphone and record it.

I don't have the SPDIF cable right now.

Hope you can help me

Greetz,

Wheresthedug · September 5, 2021 at 5:44 PM

when you say speaker do you mean the one attached to the speaker out on your powered Kemper or monitors attached to your computer?

If the Kemper speaker go to Output Menu and step through until the page with PowerAmp On tick box and untick it.

If you mean monitors attached to computer just turn the monitor output on the interface down. Focusrite interfaces don’t automatically mute the main output when headphones are connected.

ChickenPicker · September 5, 2021 at 5:49 PM

Wow ..!!

Thanks so much

Indeed I meant the 1 x 12" cab where my Kemper on top

Wheresthedug · September 5, 2021 at 7:50 PM

You can either turn off the power amp as I mentioned earlier or go into the Output menu and unlik all volumes except Monitor Out from the Master Volume knob. This way you can turn to monitor volume up or down as required without affecting the level going to your interface.