I have the latest OS release as well as the last RM release. I love the ability to edit from my PC, however, I am having an issue with morphing. I noticed that I could not make adjustments between the two channels and get them to stick. I racked my brain trying to figure it out, but couldn't. I searched for answers in this forum and found none. I have since discovered that if I make the changes on the unit itself, they stick, but I still can't make changes that stick from Rig manager.
Morph settings from Rig manager.
-
misteraxe -
November 19, 2020 at 1:24 AM -
Thread is marked as Resolved.
-
-
I’ve noticed the same issue as well, fingers crossed they solve the issue!
-
I was hoping it was a problem that could be solved. You can edit a morph setting in rig manager as long as it was initiated on the front panel, but you can't initiate a morphed setting from rig manager.
-
I cannot reproduce a problem. In Rig Manager you normally enter the base sound values of continuous parameters. Holding CTRL on the keyboard while dialing will open a morphing range adn set the morph sound value of the parameters. Base sound vlaue is marked by a blue dot, morph sound value is marked by a red dot.
Don't forget to store. Then it sticks.
-
I can confirm Burkhard's post. This works as intended for me as well.
-
I cannot reproduce a problem. In Rig Manager you normally enter the base sound values of continuous parameters. Holding CTRL on the keyboard while dialing will open a morphing range adn set the morph sound value of the parameters. Base sound vlaue is marked by a blue dot, morph sound value is marked by a red dot.
Don't forget to store. Then it sticks.
Thanks! I was not aware that I should use the ctrl key to initiate a morphing range. I will try that. Meanwhile, I have had several crashes when trying to turn effects on and off through morph channels. Not sure if that is even possible, but I am just now exploring morphing and wanted to try it.
-
I just tried it and I am thrilled to finally have an answer to this frustrating issue. If this was covered in the manual, I missed it, but I appreciate your response very much, as it has relieved me from further frustration.
-
Perfect!
Yes, it's covered in the Rig Manager manual.
And our engineering is planning a modification which will additionally allow to enter morph values in Rig Manager without holding CTRL, while the Morph Pedal rests in toe position.