Best way to connect the BAM 200

KenHPstudio · October 3, 2020 at 1:45 AM

Hey Guys,

Just picked up a BAM 200, want to connect to my unpowered kemper and my 2x12 mesa cab vintage 30's. What is the best way to connect to the Kemper? Also the BAM say 4 ohms for the speaker output my Cabinet is 8 ohms is this a problem? Regards Ken ..

Ruefus · October 5, 2020 at 1:49 AM

I believe it says 4ohm minimum load. You'll be fine with an 8ohm cab. Class D amps (and lots of other solid state designs) can handle multiple impedance loads.

Roeffel · October 5, 2020 at 7:39 AM

I rewired my 2x12 for 4 ohm to fully benefit the 200 W power. 8 ohm was ok too, but now it's insane loud

KenHPstudio · October 7, 2020 at 9:42 PM

Thanks Guy's.. Did you connect the direct out or Monitor out of the Kemper to the input of the BAM? and did you change the db's as some have suggested?