Recently, my guitar sounds cuts off about 10-15 minutes into playing. Other audio in continues, just the front guitar inout cuts out, (goes silent). When I restart the Kemper it comes on again, (for about 10-15 minutes0>. Anyone else have this issue?
Guitar sound goes dead
-
2bb75a43ef782154e8b3454752153f5c50aae039 -
February 1, 2020 at 12:03 AM -
Thread is marked as Resolved.
-
-
ok I've tried changing cords, and turning all the buttons I can on and off...still my guitar sound cuts off after about 20 minutes.....this happens through headphones or monitors.....should I reset the Kemper to factory settings? Hullo?
-
Which unit do you use? Are the vents in the unit blocked by anything or is it hotter than usual?
-
I had similar issue. It went away after a factory reset and removing my expression pedal.
-
Using the regular profiler. Don't think there are any issues with clearance or vents. Will try the factory reset...thank you!
-
You need to narrow in,
if this is an issue of the output signal (OUTPUT LED flickering, relevant output volumes at intended level)
or the input signal (is the INPUT LED reflecting your playing).
Is anything else in the signal chain e. g. in an effect loop and is that equipment functional?
Have you checked guitar and cable?
Are any pedals and switches connected for example an expression pedal to control volume, at which level is the bar of the Volume Pedal in System Settings when the issue happens. What if you disconnect that pedal....
Or is MIDI equipment involved.