How are you profiling people using profiled pedals...I understand profiling them as part of a rig but are some of you profiling them separately and if so how are you using them?
Profiling Pedals
-
60Strat -
April 26, 2012 at 6:31 PM -
Closed -
Thread is marked as Resolved.
-
-
If you profile them separately they are going anyway to land in an amp block. You cannot use them as stomps
-
Just thinking out loud here... What if you were to profile them seperately.. Place them in the Tar file under, "Stomp" and then restore. I am not saying anyone should do this. I am just thinking it could be done. I do not know if it will F-up your system.
-
Extremely bad idea! The stomps are modeled, the folder contain only the saved settings for them. Is not like with Cabs where they are profiled.
-
Just thinking out loud here... What if you were to profile them seperately.. Place them in the Tar file under, "Stomp" and then restore. I am not saying anyone should do this. I am just thinking it could be done. I do not know if it will F-up your system.
Then a nuclear blast would happen in my studio room at the turning on of the KPA