Is anyone else experiencing this with 5.7.7.14448 release?
If I add a delay into either of those slots the rig volume drops by about half. This doesn't happen with slot X or MOD.
Is anyone else experiencing this with 5.7.7.14448 release?
If I add a delay into either of those slots the rig volume drops by about half. This doesn't happen with slot X or MOD.
maybe the vol setting inside the DEL ?
No mate, the exact same delay settings copied and pasted to other blocks work fine.
I take blank profile (no effects any where so all blocks are blank only the stack section active). If I add a delay to X or MOD it works as expected and just adds delay. Copy that exact block to DEL or REV and the whole rig drops by 3 dB or so. None of the parameters have changed in the settings anywhere I look.
The parameter "DLY+REV Routing" in Rig Settings has an influence as it determines the signal routing in the modules DLY and REV. Details can be found in the Main Manual.
Will check this out Burkhard and report back.
This is the first time I've updated to the firmware since the initial update that included the new reverbs was released so assuming something has changed there.
DLY+REV Routing moved from the reverb effects (former name Del+Rev Balance) to the Rig Menu, because module REV is now flexible and could contain all kind of effects.
burkard thanks. My rigs were all set to -100 there