Hello,
Just starting on the Kemper I got this message "Updating analboard firmware" and then - boot in progress .. please be patient - and it looped for almost two hours ....
is there a process to follow?
Thank you for your help
Updating analboard firmware
-
Alex_General_Lee -
September 11, 2018 at 8:55 PM -
Thread is marked as Resolved.
-
-
Please open a support ticket.
-
Very strange ....
-
That’s weird - what’s an anal board anyway
-
This sounds painful, something that you primary care physician would recommend after a certain age
-
That's a new one. Hope that "cleared up" for you!
-
That’s weird - what’s an anal board anyway
I wondered this too.
Best explanation I could come up with is it's a rough board for your dog to scrape its ass on when it has worms.
The "firmware" part of the description must refer to its durability in retaining its roughness and surviving countless washes.
-
I wondered this too.
Best explanation I could come up with is it's a rough board for your dog to scrape its ass on when it has worms.The "firmware" part of the description must refer to its durability in retaining its roughness and surviving countless washes.
(needed a rolling on the floor laughing emoji)
-
That’s weird - what’s an anal board anyway
It's in the output section. I'm guessing the sphincter hemorrhoid suppression circuit has failed and needs to be replaced.