Expression Pedal = Volume = No Spill Over Default?

mixohoytian · August 14, 2017 at 11:48 PM

Hi there, I have an expression pedal plugged into my Ground Control.

The kemper is set to volume as a default, which is what I want, but when I do volume swells, there is spill over.

How can I change that?

Burkhard · August 17, 2017 at 1:31 PM

I'm not exactly sure, I understand the scenario.

It appears, your expression pedal is controlling pedal volume as it should. You can check this on page Pedal Links in the System Settings. Expression pedal in heel position = no bar, expression pedal in toe position = full bar.

The question, if you have delay/reverb spillover or not depends on the location of the virtual volume pedal in the Profiler signal chain. You determine this by Rig in the Rig Settings, page Volume Pedal Settings. If you set Location to Post Effects you control the volume behind the DLY and REV Modules and therefor cut the effect tails off.

There is a dedicated paragraph about the Volume Pedal in the Reference Manual covering this and other aspects.