Just received my pedal from Kemper Colorado. I know I'll need a TS and a TRS cable, but what kind of cable are you folks using?
Thanks!
Don
Just received my pedal from Kemper Colorado. I know I'll need a TS and a TRS cable, but what kind of cable are you folks using?
Thanks!
Don
Hi Don since I have 6 of those pedals and 2 kempers I wanted fair priced high end cables (I am more fussy on music gear than woman or beer )
I tried a few what's left are the Jim Dunlop MXR cables and work great
Now I just need to purchase another set of feet.
Ash
@Mitsumati, I'm using 4 of these bad boys. 1.5' long, dual right-angle TRS cables to control my two EP1-KP's. Yes, I realize that I only needed 2 TRS and 2 TS cables, but I like keeping things consistent.
https://store.strymon.net/right-angle-trs-cable
Good luck.
Because i use my missons near to the remote i bought cheap and short trs and tr patch cable. It works well.
The controller Output needs a TRS-cable
The switch Output needs a TR-cable
I solder them by myself and never had a problem
The controller Output needs a TRS-cable
The switch Output needs a TR-cableI solder them by myself and never had a problem
Just to be sure. Do you really mean TR? As in Tip Ring, which means you need a TRS- or stereo jack? Or is it TS, as in Tip Sleeve?
For the controller-output of the pedal you'll need a TRS-cable (S-for stereo)
The second output-jack ist the switch of the pedal (under the toe). This will need a TR-cable
It's actually TS and TRS cables. TS = Tip Sleeve, TRS = Tip, Ring, Sleeve. I'm with Eltzejupp, I use cheap right angle, TRS cables to go from Kemper Remote to Mission pedals,
Thank you all. I wired up a couple of cables and it works fine.