Hi there,
My KPA has been working flawlessly since I had it. Today I had a rehearsal and set up my Fractal MFC-101 to control the KPA (which was a breeze BTW!). Everything works as expected however I would say that every one in 5 program changes resulted in the KPA crashing. I've not had a crash from an IA change or from my wah etc.. only on program changes. I resulted to switching rigs manually in the end as the reboot time is so long.
I'll send support an email with the fault code but I just wondered if anyone had any tips on using the MFC with the KPA?
I'm running the latest FW on both units (1.0.3 beta on KPA) I have switched off AxeFX mode on the MFC. I've only switched the IAs that I use to global, not sure if I need to do this for all of them?
I'll probably do a factory reset on the controller and set it up from scratch when I get chance.
I hope that it's not booby trapped to crash the KPA!
Cheers
Spence