Hi all !
All same settings / set up as the SM57 Profiles here:-
http://www.kemper-amps.com/forum/index.ph…3485#post213485
Now also Profliled with a Rode NT2A Condensor Mic
These 2 profiles were done with the exact same everything as the SM57 setup except that now I used a Rode NT2A condenser.
Both the SM57 and Rode NT2A are *great* mic's - the Rode NT2A is however cleaner, flatter and has a broader fuller range - on loud rock guitar cabs, the Rode NT2A doesn't have the traditional SM "honky-ness" in the midrange.
Not saying the Rode NT2A is better or worse - its just a bit different - if you thought the SM57 profiles were a bit too " mid-rangey " you will love the RodeNT2A versions ......but again, its purely personal preference.
Please note:- To keep these NT2A profiles as close to possible and real [ when compared to the real amp ] I did not run the NT2A through another Mixer Pre just to 48v phantom power it - rather I used an external stand-alone 48v phantom power supply - so the NT2A was kept as neutral as possible before it hit the Kemper
Just go to the Rig Exchange and search for " DZ CH " you will find:- DZ CH 1 RODE NT2A and DZ CH 2 RODE NT2A .
The Wah is ByPass at stop and the Pure Flat Boost was added purely for volume level matching purposes.
The EQ is a mid-boost to " rock-it-up " when/if needed
To my ears, these Rode NT2A versions are -even better- for those of you using " Cab OFF " with a real Cab.
Hope some of you find them useful.
Ben