Hi all !
I have. 3.0. on and all is good ....... so far
On my. 3.0. Kemper I have only the 11 Profiles that I use ...... nice and lean
My Issue / Problem
If I want to load up. ONLY the new 49 Merged/Direct Profiles that I downloaded in the Feb 15
"49 Pack" ...... how do I do this. ?
With FW 2.8 and prior, I formatted USB Stick, put whatever profiles I wanted on it and it all worded fine.
However ......... with 3.0. when I use the same process ie: format a USB stick, copy the 49 new profiles on to it and pop it in, it starts to do the importing but then stops saying the profiles are already on my 3.0 KPA ........ but they aren't ?!?!?
I know I can do a FW 3.0 Factory re-install and it will put all 348 profiles including the 49 new ones, but I really don't want to do it this way and then I will have all these extra profiles I don't use / want / need.
Is there a simple way to just get the new 49 profiles on to an existing 3.0 KPA without having to use a computer connected to it with Rig Manager .... as I have never had to do this before
Thanks,
Ben