Hi
I've just uploaded a bunch of profiles I made with my BAT Sarcophagus pedal.
The Sarcophagus is actually 2 fuzz pedals in one : Pharaoh & LSTR.
You can combine them or play them alone.
Note that I wanted to create some Sarcophagus profiles with both pedals turned on but the Kemper always complained about too much noise, unless the fuzz amount was ridiculous.
So you only get separate Pharaoh & LSTR
The LSTR is basically a Big Muff like pedal, so I put the emphasis on the Pharaoh which has its own character.
Here are some youtube demos:
http://www.youtube.com/watch?v=pwnkpf5En6U
http://www.youtube.com/watch?v=sRYBr3n5CYA
The profiles have been made with a Line 6 DT25 tube amp, through the cab simulated output.
As this simulation is not very good I replaced the cab with one that works well for me.
Feel free to experiment with other cabs.
For each settings, I made 2 profiles:
A : clean channel (topology 1)
B : drive channel (topology 2)
Some noticeable profiles, for which I used the settings that you can see in the videos above:
Pharaoh 1: Clean headroom , low gain (justnick)
Pharaoh 2: Stoner , neck
Pharaoh 3: Hendrix blues (justnick)
Pharaoh 4: Crossroads Clapton
Pharaoh 5: Stoner , Mastodont
Pharaoh 6: Muse
Pharaoh 7: Articulated fuzz tone (justnick)