Need Help using kemper with scarlet 2i2 interface into reaper

Quote from jester22

hi saw a guy on you tube recording with a kemper and scarelt 2i2 wuth great results need some help with what lead to take from kemper to scarlet and where to come out from

regards

rob

I come out from the normal guitar cable out of the kemper.....I have the (8i6 scarlett), straight into the scarlett input.... records very nicely.. havent figured out how to use the mixcraft software yet but haven't needed it at all luckily

Or if the Scarlett has an SP/Dif input, you can use that... the KPA's sp/dif "output" to the Scarlett sp/dif "input". This works in Reaper, just remember to setup your I/O properly.

Enjoy.

I have a 2i2. You can either use the Monitor out, or the main outs going into both channels of the 2i2 if you want to record stereo. Make sure the switch is on 'line' and adjust the levels until the ring around the knobs don't turn red. It's a great little device.

A good practise is to record with your levels set so that your peaks go up to the -12dB range. No point of having your levels any hotter, you'll just lose headroom on your mix.