Low cut high cut only in monitor

Lance-a-not · May 4, 2024 at 9:08 PM

I remember asking about this a while back, but any chance of implementing this?

My direct sound is perfect, I haven't changed it in a decade... But through cabs (I have a Power Rack) I need to use a different setting and then my direct sound goes down the drain.

Couldn't find any info with search

AleFretMaster · May 20, 2024 at 8:28 AM

Indeed a link button would be nice and effective

Dynochrome · June 20, 2024 at 7:33 PM New

I've always wanted this too. I would think it could be done in the software? I would cut what goes out front differently that what goes through my monitor. I know there is an EQ (that I never use) I don't ever want to change the tone, just fix some top or bottom.

Dynochrome · June 20, 2024 at 7:36 PM New

Quote from AleFretMaster

Indeed a link button would be nice and effective

Aren't they "linked" now? The LPF/HPF works for both monitors and mains. What is needed is separate HPF & LPF for mains and monitors.

Lance-a-not · June 20, 2024 at 11:18 PM New

Quote from Dynochrome

Aren't they "linked" now? The LPF/HPF works for both monitors and mains. What is needed is separate HPF & LPF for mains and monitors.

Yes, this! (please )

The monitor EQ is useful, but not the same... at least that I can dial up.

My work around is just EQing the board for direct, but it isn't quite the same.

Low cut high cut only in monitor

Similar Threads

Kemper: better with frfr or through power amp and speaker

Continued Struggle with gear.

How do you set your output EQ, LC and HC filters with Powered Kabinets?

Kemper monitoring in loud stage situations