Motu and Kemper Stage

nwmusic32 · September 26, 2022 at 12:45 AM

Hey Everyone,

So I have Motu M2 as my interface. Currently I go from the Stage’s XLR main outputs to the XLR inputs of the Motu M2.

I recently discovered the Motu manual says don’t use XLR +4 for inputs, use 1/4inch for +4. I am assuming this is +4dB which the Kemper manual says the XLR output is.

I’m getting a bit overwhelmed- how should I connect my Stage to the Motu M2?

Wheresthedug · September 26, 2022 at 9:40 AM

XLR to TRS cables for best noise rejection.

If short cables runs in relatively clean environment then TS to TS will be fine.