Reported at least by another user...if you have too please report
thx
Bruno
Reported at least by another user...if you have too please report
thx
Bruno
Yes, I reported this same issue in the "update 1.1.1" thread.
Hi,
I would like to know the status on that issue, I rely exclusively on spdif output so I didn't perfrom the update because of this report. Does it have been reproduce by support? Does it affect everybody?
Thanks.
Reported at least by another user...if you have too please report
thx
Bruno
Hello, we have not been able to reproduce any of this. May I ask you to please open a support case and ideally send us a small recording of the noise, so that we are getting an idea.
Ive had this problem for months i was hoping this firmware would fix it. To the op a quick work around for this is turn all fx stomps and stomp x off i don't mean bypass them set them all to non this is the only way for me to avoid crackles
Hello, we have not been able to reproduce any of this. May I ask you to please open a support case and ideally send us a small recording of the noise, so that we are getting an idea.
It doesn't happen on all rigs ...You have my backup;.you can check the rig called " * AXE FX EURO UBER 4"
thx
BRUNO
Finally did the update and the original problem when switching rig seems to be gone, but as Bruno and Chris pointed out I also have crazy crackling noise happening on certain rig when muting/unmuting FX. Switching rig seems to cure it when it happens. One rig I have it a lot is Keith Merrow 5150 SIG RED profile, try muting/unmuting the Tube Screamer/EQ FX.
Thanks.
+1 , it is very annoying.
Can we have a confirmation that the problem have been reproduce by support?
HI guys
I'm really disappointed! I've the clicking problem on my unit too. On Spdif and Master Output both. it comes not always , but sometimes bypassing the reverb ( but 3 or 5 minutes later it comes again), or bypassing the Pedals (Stomps).
The firmware it the last one: 1.1.1.7461B and i've only the factory profiles.
Any news from Kemper about this issue?
Really depressed+1
Using the output jack to record....thumbs down
Master works fine here with old firmware.
I never used the spdif for the moment so...
(i'm a happy kemper again..kpa fixed today)
I get crackling noises when the sample rate is incorrect. This doesn't sound like that perhaps, but it happens to me occasionally. I simply change it in Logic Studio and then it works fine. Sometimes, when I'm not in Logic, but still connected to the computer I hear it through my monitors, but once again this is due to a sample rate being wrong.