Mucking around using a Kemper Rack to profile my Dirty Shirley head through a Torpedo Captor X. The noise gate in the Captor X is disabled. After profiling, I get a warning that a noise gate was detected. The resulting profile is lower gain than the reference amp, even after refinement.
As a troubleshooting step, I connected a cable directly between send and return and profiled the cable. It resulted in a successful clean profile without the warning.
I know others are using a Captor X to profile, but I haven't heard reports of them getting the noise gate error. I've opened a case with Kemper support and am waiting to hear back, but I'm curious if anyone else has experienced this issue.
Torpedo Captor X noise gate warning when profiling
-
Karl_Houseknecht -
July 1, 2022 at 3:41 PM -
Thread is marked as Resolved.
-
-
I see this is an older post but I just saw the same thing.
I'm running a Sol Invictus pedal into a Mesa Mark V power amp into the Torpedo Captor X. I just hit OK but I noticed a lot of the low end seemed to be missing when comparing the profile to the Reference amp.
Not sure if you resolved this or not? -
I've had it when profiling an amp with no noise gate in the loop. Don't worry about it.
-
Cool thanks for the response!