Dear Forum Men,
I'm stumbled upon a problem today with my Kemper's midi out when I tried to externally sync the tempo of my Boss Slicer SL-20 pedal. (Can't be set digitally which is why I link it up to an external source)
Things I've checked:
- Cable (Partially ruling out being a total numpty...perhaps )
- Synced slicer successfully to boss looper (Ruling out defective midi in port on slicer)
- Tempo enabled on Kemper
- Checked each midi channel on Kemper ranging from Omni to 14 - no message received on slicer.
- The Kemper midi in works - I have a HD500 setup to control volume and switch on/off stomps. Tried this connected/disconnected to check for interference.
Also...the slicer doesn't allow you to adjust the tempo once it's receiving midi messages from another source - the fact that I can adjust it shows it's not receiving anything (?) I'm stuck for an answer so I'd thought I'd ring the 'numpty bell' and hope someone can help.
UPDATE: Ah... it appears I can't send any messages at all from the KPA midi out - just tested it in Ableton and it doesn't pick up anything... Is the Kemper not able to send midi messages out at this point?
Any assistance would be gratefully received - I've bound to have overlooked something rudimentary that will no doubt end in me going outside, falling to my knees, stretching my hands to the heavens and loudly proclaiming, " I've been a fool "
Cheers,
Brett of Numptyville