Hello Folks,
I'm new to the Kemper world.. Hello all! So my title kind of explains what is happening. I don't really care for FRFR sound in the room, so I purchased an older QSC RMX 850 stereo power amp. My first hour it was sounding terrible, but then I found that there was a clipping and low filter switch turned on the power amp and that was really killing my sound. So after I get past that sound dilemma the Kemper sound pretty sweet running through my Friedman 2X12 with V30s.. I can even run it without output high and low filters and it sounds pretty good (I didn't expect that).
Anyway, It seems that my reverbs and delays don't work anymore.
Here is how i have everything setup: Guitar ==> Kemper input.. then.... Kemper monitor out ==> channel One of the power amp ==> into speaker cab. Within master output section I set Cab to always be off. I set my monitor and master to be mono.
Why are my delays and reverbs not working anymore.. it has to be something simple.
Thanks folks, Ralph
PS: Moderators.. if I posted in the wrong section please feel free to move this thread to the appropriate one. Thanks