Been profiling an old 78 Marshall JMP 50w 1987 model.
The studio profile is perfectly fine but all of a sudden, the DI profiles are freaking out.
This was all working the other day when I first set it up to test it and I have changed nothing.
Signal chain is
Guitar into Kemper Toaster front inout.
Send to Marshall
Marshall speaker out into Suhr Reactive load iR
Suhr output to Kemper return.
For the studio profile, I have been using the IR out on the Suhr Reactive Load. For the DI, I just switch to the unfiltered lout on the Suhr.
What is now happening is that the DI profile is overly distorted and muffled. This was not happening the other day when I first set this up. Now I have the amp tweaked, the DI profile is not happening at all.
The weeks before, I have been using the exact same setup for a couple of Boogie Mk3’s and all was fine. Studio, DI and Merged profiles were all good.
Anyone got any ideas? Does the Kemper need resetting and how do I do that without losing everything. It’s all backed up to USB
OS on the toaster is 7.1.5
Some additional info
The DI sounds fine until it’s profiled. I have the same IR loaded into Logic Space Designer so when refining DI profiles, I can hear them better. So, once getting to the process of doing the DI profile, it all sounds normal with the IR loaded in Logic. Just when the DI is profiled, what comes back is nothing like what the Profiler was sent. It is muddy and very distorted.
Have also sent a report to Kemper but just wondered if anyone has come across this and found a solution.