Post Stomps / pre stack output option.

reznor · February 2, 2020 at 10:54 AM

Is there a way to get a post stomp/pre stack signal from one of the outputs (to the front of an tube amp) and still have the entire rig signal available for FOH of FRFR ?

Like Monitor output option "post stomp", or even better... like "Monitor cab off" - "Monitor stack off"

Thanks

Burkhard · February 2, 2020 at 6:38 PM

You could try to place a Loop Mono in Module D, crank its Mix down, and feed the signal from the SEND (or SEND 1) into your tube amp.

But don't understand, why you don't want to use your PROFILER as your all in one device!? Just see more equipment and complexity and weight, and no value add.

reznor · February 3, 2020 at 9:52 AM

Quote from Burkhard

You could try to place a Loop Mono in Module D, crank its Mix down, and feed the signal from the SEND (or SEND 1) into your tube amp.

But don't understand, why you don't want to use your PROFILER as your all in one device!? Just see more equipment and complexity and weight, and no value add.

Thanks, i will give that a try...didn't think to use the mix parameter...

I have non powered KPAs and instead of having to use active monitors, i like the sound of my combos that don't have FX loops unfortunately