Morphed Effect Default Value when Switching Rigs

ryanclenney · March 21, 2018 at 6:45 PM

I have an expression pedal set to morph the mix parameter of a stereo loop. I'm in performance mode, and the stereo loop is 'locked' across each rig in the performance.

Problem - when switching rigs in the performance, even when the expression pedal is at toe position, it reverts to 0 mix. I have to rock the expression pedal back a bit to get it to reset the value.

How do I set it up so that it picks up the 'current' position of the expression pedal when I switch rigs, so that if it's at toe on one rig, when I switch to another rig, it stays at 100% mix?

Thanks in advance!

Ryan

Ingolf · March 21, 2018 at 8:58 PM

Welcome.
Morphing is always between state A and state B of any given parameter set.
The Profiler can’t pickup any in-between state when switching a rig.
It will always default to state A (which could as well be the maximum of a parameter though)

ryanclenney · March 21, 2018 at 9:23 PM

Thank you! That’s helpful. And appreciate the welcome. Kemper arrived 6 days ago. Haven’t gotten much done since!