What are these 2 LEDS?

This is for morphing (Or at least that's what I use it for).

So, click the stomp pedal so the upper of the 2 LEDS is active. Change amp perimeters, for example a mid boost and gain boost for a solo for example. Or you could also add an effect as well. Click save on the kemper.

Now when you click the button for the second time, it will morph to the new perimeters! Cick again and it goes back to your stock sound.

I'm rubbish at explaining but hope that makes sense!

Quote from okami_itto

Hello,
I'm new to the Kemper Profiler.

I wonder why every button 1-5 has 2 LEDs?
as is step on the same button twice the selectet rig stays the same, but the bottom LED switches to the top LEDs,
for what reason?

Thanx

For a deeper explanation and additional settings (morph crossfade times etc.) check out the morphing section in the reference manual : click here

One to show what kind of stomp is in that slot (e.g. red for overdrive, green for delay) and the other to tell you if it's on or not.

Morphing as the guys said.Normal Rig lower LED , morphed Rig upper LED