Hello, I see in the manual etc stated that the Direct Output is a unbalanced Output (Low impedance).
I want to set this on up for Guitar DI recording straight to my Interface (+4dB Line Level XLR Input) so I set my Kemper Direct Output to Git Analog to the signal up to Line level, now the question should I go for
1.just TRS from Direct Out to Interface XLR
balanced
2. or TRS - XLR cable and
better Re-wire the TRS side??
like -
The connecting cable have the cold signal conductor of the cable tied to ground at the source-side only (the unbalanced end of the cable). The load-side of the cable will be connected in a typical balanced configuration
What you guys can suggest me to make it right,
Iam not too much a tech guy,the kemper specs and discuss in forum about the Direct Output confusing me a little.