This just occurred to me for some reason. Since most profile makers are not sitting around working out how they are mic'ing cabs with each other (obviously), does it stand to reason if I were to use an Mbritt profile on one or 2 tracks and then a TAF profile on one or two others for layered rhythm guitars, wouldn't there be some inherent phase issues?
I ask mostly because I am looking for a good solution when profiling different amps at different times to make sure that when I AM multi tracking my rhythm guitars this is a non issue.
Am I overthinking this?
I know Tim Owens made a jig to measure how far over from the cone and how far back from the speaker his mic's are. I assume there can still end up being enough variance from session to session to still cause a potential issue though.