I'm not sure if this would be a possible, but I would like to be able to send a Guitar DI from my DAW (Pro tools) to the Kemper Return input (like I would for re-amping) and be able to route this signal to the Kemper's Direct output.
I would like this ability so I'd be able to send a Guitar DI through the Kemper to the Real Amp in the room, in essence simulating me playing the guitar, but leaving me free to tweak the Real Amp and find and note down all the sweet-spots for profiling later.
To clarify, I wouldn't want this feature for profiling, but just to find all the settings to profile afterwards.
I have 5 guitars I use, and when I profile I like to profile an amp for each guitar respectively. By using DI's, I would be able to save on lugging all my guitars to a profiling session and having to change strings for every session as I would have DI's saved of each guitar played with new strings. To test each profile I would only need 1 guitar to check between the Profile and the Reference amp.
Hope this makes sense, I did post a question about this in the Questions and Answers forum as I wasn't sure if this was possible in a more up to date firmware, I'm still on 3.1. The only workaround I have found is to send the DI through a Re-amping box into the Front Input of the Kemper, I was hoping for a simpler solution.
Thanks for reading guys.
[Blocked Image: http://i1056.photobucket.com/albums/t378/kizzertron/kemper%20request_zpsm4jshvez.jpg]