i would like to know if anybody had this issue with the midi in.... so i was at a gig last night and my midi stopped switching patches in performance mode. i use a tech 21 midi mouse to do my switching and always works fine. i tried to shut down the kemper and reboot it and the same problem was there. i unplugged the midi cables on both ends and plugged back in.... no change. so i started switching patches manually and halfway through the 1st set it started working again. im on 3.0 with the kemper. i am going to check cables today but i thought i would see if this happened to anyone or if this is an issue on the kemper side.
midi in problem
-
boblaz -
May 2, 2015 at 4:49 PM -
Thread is marked as Resolved.
-
-
no problems here over the last four month - since I got my Kemper.
Midi cable? -
Are you using 3.0.2? The earlier 3.0 would not transmit on Omni, think I had to move to Midi channel 2 to get it to work. I updated to 3.0.2 and it was fixed.
-
im not transmitting midi. just sending it in to the kemper for patch changes in performance mode. i probably should upgrade though to 3.02.
-
Yup had the same problem sending midi messages to the Kemper with 3.0, just update to 3.0.2 and it goes away. If you decide to stay on 3.0 just set your controller to send out to the Kemper on channel 2 and Kemper to receive on channel 2 and it will work fine.
-
thanks for this info, booyah. much appreciated!