I've already filled out a support ticket on this; but since it's a weekend I thought I'd try here too:
I loaded 3.0.2 yesterday and hooked up the remote for the 1st time. Initially, the slot assignments didn't work correctly and only a couple of the slot positions would switch.
So, I performed a System Reset (after a backup), restored the backup, and tried again. Now the slot assignments work as expected,but.......
....now these are no LEDs working on the remote. The LCD works just fine, but not the LEDs. Before the system reset, the few foot switches that did anything had LEDs that worked. Now, nada.
Any ideas?