NOISE GATE

Quote from alwainwright

@VCuomo - Just tried the save/restore of the noise gate on my KPA and it works as noted in the manual. I should mention I tried this in browser mode. Try this:

1. Hold your lock button down and make sure the "Input" light is not on. (didn't work for me until I noticed that the input light was on (locked))
2. Pick a rig (load). Adjust noise gate to your liking.
3. Save rig.
4. Move noise gate setting to a different set point.
5. Reload your saved rig and it should go back to what value you saved as.

Update: Also tried this in performance mode and it worked as advertised.

If this doesn't work, you may want to contact support. I am on OS 2.6 beta.

Thanks, I'll give this a try! Just out of curiosity, did you power-off the KPA, then power it back on and check the noise gate setting?

@VCuomo - No I didn't cycle the power. Since I was loading/reloading stored rigs, I wouldn't expect a power cycle to change the behavior of the input settings. But anything is possible. Let us know if you have any luck in getting this feature to work for you.