Reamping Signal with internal Wah

saschak · June 26, 2014 at 8:58 AM

Hi,

i was recently recording tracks for our upcoming EP using the Kemper. I always recorded one Di signal which will be used for reamping and one amped signal.

Now i would have to record a guitar solo that requires a wah. So question is which output setting must i use to get a di signal that is including the wah?

Thanks, Sascha

Lokasenna · June 26, 2014 at 1:06 PM

I think your only options are:

a) Use the effect send right after the wah
b) Use the Parallel Path blended at 100% (I think you can do that) to send the DI+Wah signal to your recording outs, and then just monitor while you play from a different set of outs using Stack or Mod as the source.

HELL-G · June 26, 2014 at 11:14 PM

If you use the Profilers Wha controlled via MIDI you may record the MIDI data sent by your controller in your DAW. Midi CC #1. Send the recorded data to your Profiler to reproduce the Wha performance when reamping.