Why is there no documentation on how to turn on send and return to outboard gear? Seemingly connecting my BBE 882i the correct way in the back of the Kemper produces no desired result, in or out. Is there some way to turn on a loop FX in the Kemper for the signal to cycle thru the outboard gear?
The BBE works perfectly routing it thru the front of the Kemper, but I don't want all those patch cable in the front when it should obviously work in the back. 
Sends & Returns
-
musaicsong -
April 20, 2014 at 2:47 AM -
Closed -
Thread is marked as Resolved.
-
Place the loop into whatever slot you awnt it in. It's in the KPA like an effect, so scroll through the effects option and you'll see options for loop. That will route the signal out to the BBE then make sure you're cabled up correctly.
Sean
-
Why is there no documentation on how to turn on send and return to outboard gear?
Reference Manual, version 2.1 at least, page 52.
I know we're mostly men on this forum, but you *are* allowed to read the instructions.
-
Why don't you put the BBE at the end of the signal chain (Monitor or Main Out --> BBE --> cab)? The KPA's loop is BEFORE delay and reverb!
-
Place the loop into whatever slot you awnt it in. It's in the KPA like an effect, so scroll through the effects option and you'll see options for loop. That will route the signal out to the BBE then make sure you're cabled up correctly.
Sean
Thanks a lot Sean. I hope I have time this week to get it right.
-
Why don't you put the BBE at the end of the signal chain (Monitor or Main Out --> BBE --> cab)? The KPA's loop is BEFORE delay and reverb!
Try every way possible till best sound is achieved, is how I work. Thanks for the suggestion.
