Rigs not changing in browser

Hi , I am new to Kemper this week having got a Kemper Stage and so have been trying to familiarise myself with things. Have spent last few days building performances, adding effects etc with some success.However part way through tonight’s session things have suddenly gone wrong. Now when I go to browser and change rigs, the dial moves me through new rig titles but the amp sound doesn’t change, it just keep the first sound playing.

Also as I turn browser knob the led on the performance stomp buttons light up and move from number to number as I move through rigs.(hadn’t noticed that before)

Same thing applies now if I go through effects, I can scroll through titles but sound doesn’t change.

It appeared to start after I was trying to load effects to performance.

What I have pressed wrong?

Thanks

Quote from Kemper Support #1

check your output source settings in the output menu and make sure to use Master Stereo or Master Mono for the outputs that you use for monitoring.

Looked at those and and all four outputs are set to either stereo or mono

Quote from Bakersounds

By the way, hello and welcome ✌️

Hi and thanks

Quote from Bakersounds

Vintage steve are you talking about Rig Manager or on the Stage itself?

I myself had also trouble from time to time using Rig Manager. As you say, in browser mode i also couldn't go further from one Rig to another. In this case a restart of Rig Manager was helpful.

Quote from Bakersounds

Vintage steve are you talking about Rig Manager or on the Stage itself?

I myself had also trouble from time to time using Rig Manager. As you say, in browser mode i also couldn't go further from one Rig to another. In this case a restart of Rig Manager was helpful.

it’s on the stage itself. Not connected to computer at all yet.

Ok, just trying things again there was a lock on bit shaper, took that off but didn’t solve problem, however, I have just discovered that if I browse through rigs and then press down on browser knob it will change amps and are able to play that amp.

I’m sure it wasn’t like that before? I could just turn browser knob and I could audition any amp. Also I’m sure the gain switch indicator lights would change as I scrolled past through to show how much gain there was, now as scroll through they stop on last amp setting until I press browser knob down.

That was it Autoload was off. Obviously while messing around I must have switched it off.

Thank you everyone for your help.