Hi, I would like to use my (old) X-15 to control the KPA.
Program change isn't a problem, already done.
But if I see it right, when I want to use the pedals of the X-15 I have to change the controller numbers to 1 and 7 (normally 4 + 11 in the X-15).
1) How can I do this (looked into the manual but didn't found out how so far) ?
(I want to control Wah and Delay MIx must look how to set that up in the KPA too)
2) How to set controller numbers to certain buttons ?
Afaik delay mix is not (yet) possible
Think I just found it in the X15 Manual ... but will try it tomorrow.
The test with PA was phenomenal ... my friend (ownes a GT 8 and it's programmed well!) will surely order a KPA in the following weeks ... 
Please post your findings. I also have an x-15, but have not had a chance to hook it up.
Please post your findings. I also have an x-15, but have not had a chance to hook it up.
Like I wrote in another thread ... download the manual from ART website.
http://artproaudio.com/support/manuals_spec_sheets/
On pages 5 - 6 pdf (in the document 4-5) it's described quiet well.
The controler numbers for the KPA you find in KPA reference manual.
For example: To set the button #1 in "mode" modus to switch Stomp A:
- press "mode" + 4 together
- then press "1" (LED should be highlighted already, for the other buttons press 2 - 10 or even the "bypass" button)
- then press up / down buttons and roll to "17" in the display
- press "mode"
DONE
Notice you have to activate the "mode" button then to switch Stomp A by pressing "1" (in this example).
Of course the Midi channel should be right, OMNI would be fine I think (This should be set by default).
Sweet! Thanks for posting!
great thanks a lot !!!!
