New Beta Update Acoustic Mix Control

qwertygigs · September 20, 2021 at 11:45 PM

When I store a profile in rig manager with a change to acoustic sim mix the change reverts to 100% on recall.

However this does not occur if you store change on the profiler itself.

Also my delay repeats seem distorted when used with acoustic sim.

BayouTexan · September 21, 2021 at 12:02 AM

IDK. Could the RM folder be set to "read-only"??

Where are you placing the sim? When using before the amp, and the amp is ON, I pick up a lot of noise that's hard to cancel out with the noise gate without loosing lots of dynamics.

I haven't "bonded" to that effect thus far.

qwertygigs · September 21, 2021 at 3:29 AM

I use the acoustic sim in the stomp section with amp and cab switched off.

No my save folder is not set to read only I think its a bug in the beta update.

Wheresthedug · September 22, 2021 at 8:43 AM

probably is a bug. Have you reported it directly to support. A further test that would help them trace any fault would be to see if the same behaviour occurs with the AC post stack in the stereo slots or only in the mono Stomp locations.