Hey everyone.
I'm working to setup my Ground Control Pro with my Kemper. I've used the GCP with my 11R, so I think I'm familiar enough with programming it to get by.
I have the GCP setup as 8 IAs and 4 patches. I also have the IAs set up to XMIT W/ PRESET - or transmit the MIDI CCs for each IA anytime a PC (program/patch change) occurs. So on each PC change, the Kemper could be receiving 9 MIDI messages: 1 PC and 8 IAs.
I have saved my GCP patches where the IA lights and status correspond to the Kemper's saved patches FX status.
MIDI #27 is giving me some weirdness however. It seems to take a couple of IA button clicks to "arm" MIDI CC #27 before it starts tracking with me GCP.
The only other MIDI CC I've set up is MIDI #18 (Stomp B). MIDI #18 tracks fine - i.e. switch a patch and if I enable/disable MIDI #18, Kemper responds as expected.
More weirdness: If I FIRST toggle MIDI #18 after a program change, then MIDI #27 tracks as expected.
Anyone else seen anything like this? I'm running 1.1.0.
Got to get it working properly before my band's first gig in 10 days.
Hmm... I suppose it's possible I have a residual MIDI CC programmed for my 11R that is getting transmitted and confusing things.... Just checked the 11R manual and MIDI #27 is the "Distortion or Drive" control for the overdrive pedals, so I don't think I have that programmed as an IA since it's a continuous parameter. I'll check my GCP to confirm, but I doubt that's the problem.