Stage looper output..

hiflyerint · June 14, 2021 at 9:12 PM

From the manual "Consequently, while Looper Location is set to “Output” the playback is inserted after the REV module and can only be monitored on those outputs that have their respective output source set to “Master….”.

So in another words, the looper cannot be monitored via Monitor Out?

ST · June 15, 2021 at 6:37 AM

Hi hiflyerint.

To monitor the Looper via the Monitor Out.

On the Profiler Stage.
Tap Output
On Page 1, set the Monitor Output to Master Mono or Master Stereo.

That should get you going.