For one of my guitars I have been using the Clean Sens (+1.2) for increasing the volume of all my clean profiles. My second guitar has a hot output so I had to set the Clean Sens to -5 to avoid input clipping but now my clean profiles are less loud compared to hi-gain ones. Is there a way to control the volume of the clean profiles and avoid clipping at the same time for my hot guitar? I wanted to avoid doubling of the performances as I use for each song a different performance. The input section is locked also for the performance mode and I use two different input presets. Thanks for hints.
Clean Sens for both clipping avoidance and clean sound volume control
-
m3talf0r3ver -
June 7, 2021 at 1:12 PM -
Thread is marked as Resolved.
-
-
Down and dirty way is to use your guitar volume knob.
-
Rig Volume.
-
ckemper has said several times over the years set clean send to level the volume between clean and dirty sounds but don't get hung up on the colour of the ur input light as it is very difficult to actually make the input clip. Even if it does clip it is a gentle soft clipping that shouldn't cause any problems.
-
Thanks for your inputs. Rig Volume is an obvious way but it will require separate performances for each of the guitars.
Regarding the input clipping the truth is I saw the red color and started to deal with it not really evaluating the sound going out of the profiler. I'll give it a try.
Guitar volume knob is tricky, I can't really work with it. I would prefer switch instead (metal player ).
-
Guitar volume knob is tricky, I can't really work with it. I would prefer switch instead (metal player ).
Ah, I see. It isn’t a volume knob. Its an ON/OFF knob ??