Hi,
I just received my UNO4KEMPER chip and installed in the FCB1010. First boot up, nothing happened apart from a click after a long time. Then I switched off and on again. 2nd time it came up and showed "---" on the display. (no midi cable connected)
Then I calibrated the pedals with 1+5 which worked fine, then connected it to the Kemper. The FCB display shows "00" since then. But there's no connection established. Kemper doesn't show up anything and pushing buttons on either side is not reflected on the other side.
Any ideas, suggestions would be very much appreciated.
Thanks,
Christof