Bigger feet on the Toaster

Gary_W · January 3, 2021 at 10:16 PM

Hi everyone,

I was lucky enough to pick up a Kone a few weeks ago which I’ve fitted into a decent Matamp 1x12. I’m really pleased with it but the amp handle is chunky enough that, when the Toaster sits on top, it rattles (brass sides on the handles resonate when certain notes are played at inappropriate volumes - which is half the point of the Kone )

I’ve popped some padding under the Toaster feet but.... has anyone unscrewed / replaces the feet on the Toaster with bigger ones? Happy to do this but I’d like to know if there will be a little nut inside that will fall off. Whilst I’ve had it for years and wouldn’t be breaching warranty by opening the case, I’d still rather not. I’m hoping the case is threaded and I can unscrew with no worries?

StumblinMan · January 4, 2021 at 7:24 PM

I'm in the same boat actually. Usually the chassis is threaded, because a nut bouncing around inside an electronic device is a very bad idea. I'm going to do some digging elsewhere for the same reason. Good luck!

Gary_W · January 4, 2021 at 8:36 PM

Another Gary with foot issues? We’re a dying breed :). Thanks for the reply.

I’m hopeful it’s threaded but, if you or anyone else know this for sure, it’d be good to know

Wheresthedug · January 5, 2021 at 10:07 AM

i’m sure I’ve seen this in another thread somewhere but can’t remember when or what the title was. I think it is threaded but can’t be 100% certain.