Delay tails with Reverb?

BayouTexan · December 13, 2020 at 9:16 PM

This can apply to modeling or analog effects:

Whenever I use delay (which is quite a bit lately), I can never seem to find a reverb effect to follow delay without keeping the delay tails from being distorted (muddied up). Doesn't matter if it's my pedal board, DAW plugins, or the Kemper effects.

Is this the same for you? Am I not setting something right, or is verb inherently hard to dial in after a delay tail?

Wheresthedug · December 14, 2020 at 7:52 AM

You need to run the delay and reverb in parallel for that. Go to rig menu and adjust the Delay+Reverb Routing all the way to the left.

BayouTexan · December 15, 2020 at 2:44 AM

Will do Wheresthedug !

I went to rig menu page 1 and set the DLY+REV Routing = -100%. to start. I also went to page 4 and "checked" the Parallel Signal path with the softbutton.

Those two options should really open up some great tone possibilities.

Thanks again!