Ground Control set up with Kemper

Guter11 · January 16, 2020 at 12:28 AM

I’ve looked all over the internet and in forums, but I haven’t really been able to find anything that makes setting up the GCP understandable to me. I was able to get a few rigs programmed in for the 4 bank system, but I haven’t figured out how to get access to stomps. Any advice is much appreciated.

drog · January 16, 2020 at 1:09 AM

It’s been awhile but as I remember you need to assign the midi number associated with the Kemper effect you want to use and assign that to the foot switch 1-8 that you want to use. You also need to tell the GC if the light is on or off for the switch to correspond to the state off the effect on or off.
You will need to download the Kemper midi manual to look up the midi numbers you need.

drog · January 16, 2020 at 1:16 AM

Maybe check out this older post.

Kemper and Ground Control Pro