I've run into a problem in Performance mode: the output to the amp suddenly comes stuttering, as if the input cable is defective. I changed the guitar cable first, but without improvement. Then I switched to Browse mode, and lo and behold, there the output arrives continuously at the amp. HOW THIS? (I have the latest OS release on the profiler)
Stuttering output in Profiler Stage at amp
-
CarloLf -
October 15, 2019 at 3:45 PM -
Thread is marked as Resolved.
-
-
Have you tried different rigs within the Performance, or a different Performance? I'm wondering if there is a really high noise gate setting somewhere.
-
Ah, Zappledan, you're right. Loading other rigs, the problem disappears, and loading the annoying rig again, brings it back. I have to look inside the problematic rig, what's wrong with it. Thank you!
-
On Module A, "Loop Mono" of rig the paramter "Mix" had a huge value; setting it to zero makes the problem disappear. Don't know what his "Loop Mono" means.
-
Loop Mono is used to connect an external FX pedal to the Kemper. In order to work it needs a value greater than 0 and a pedal connected using the direct out and return input. If you don’t have a pedal connected and a value of 100% it will simply kill the signal. If you have nothing in the loop and a value of between 1 and 99 you will get some signal but probably a lot of problems. If you are not using any external FX remove the Loop Mono FX type from the rig.