Hi,
I'm new to the kemper but have had it a few weeks now. I find it a bit frustrating to be honest and find the manual not much help in most cases.
I have just started using the performance mode and had four settings saved using a clean sound with just delay, reverb and chorus.
I decided to do a fifth performance as I found I had more choices of delays ect in the stomps section compared to the effects section. I got a good sound and saved it.
I then pressed the output button and all the effects have gone from my other performances except the recent one.
The monitor out stopped working to and I had to use the direct out but now it's working again. All the other performances had effects from the effects section and not the stomps section.
The effects buttons are all lit up and when I go into each effect everything is there and settings are all the same but just can't hear them.
I find the output section really confusing it comes up with output source then underneath main output, monitor output, direct output and dpd if output but nothing I change brings back the effects. Any help would be much appreciated, cheers Jonathan