Below here is what I found in the manual. Any idea what a daisy chain is? I saw in the comment section of a YouTube video from Kemper that said they were planning on adding a tutorial on how to control the Kemper from within our select DAWs, but the video isn't out yet. I'm just trying to make sense of what the manual says about it, but I'm still confused as to how to set it up. Any advice is appreciated. Should the midi cable be plugged in to midi-out on the KPA and then in to my soundcard midi-in followed by setting "UI to MIDI" in System Settings?
QuoteDisplay MoreTransmitting User Interface to MIDI Global Channel
If “UI to MIDI” is selected in System Settings, nearly all parameter changes within the PROFILER user interface, and
the connected PROFILER Remote, will be forwarded through the MIDI OUT. You could, for instance, create a daisy
chain of PROFILER units, all following whichever commands you enter on the leading PROFILER, or connected
Remote, including any Rig or Slot changes.
This stream of MIDI commands will be sent on whichever channel has been selected to be the MIDI Global Channel.
If this is set to “Omni”, MIDI channel 1 will be used for “UI to MIDI”.
✓If you intend to transmit other MIDI commands in Performance Mode, or if you want to transmit pedal controllers
simultaneously with “UI to MIDI”, make sure that you either select different MIDI channels or different MIDI outputs to
avoid logical interferences. For example, if you’re sending “UI to MIDI” via MIDI channel 1, select MIDI channel 2 and
3 for the two external devices.