Step 1: checking the unit with the Idiot's Guide -> nothing happens
Step 2: installing the Editor, setting Pedals to CC7 and CC1 -> nothing happens
Step 3: returning this fucking unit to Thomann
Step 4: using again my MUSICOMLAB EFX MKIII
Step 1: checking the unit with the Idiot's Guide -> nothing happens
Step 2: installing the Editor, setting Pedals to CC7 and CC1 -> nothing happens
Step 3: returning this fucking unit to Thomann
Step 4: using again my MUSICOMLAB EFX MKIII
You may want to check out Eurekasound's EurekaPROM. It's a physical chip that replaces the chip that ships with the FCB (takes 10-15 minutes to replace with a screwdriver). I ran an 11PROM in my FCB for a long time with my 11Rack and loved it (sold my GCP). I just upgraded to the EurekaPROM and its PP mode for the Kemper. Plus their support is fantastic and responsive. For me, 15 minutes and $35 is worth it vs. digging through manuals and PC editors.
Cheers,
Mike
I'm programming mine as we speak.
use this like it explanes nicly.
Program FCB1010It's working for me.
Hi,
I know this is an old thread but I had the same issue with my FCB-1010 and expression pedals not working.
Just bought it and I have the original eprom in it, (have ordered a UNO eprom today).
Anyway, I could not get the expression pedals working but this section from the link above helped me
How to Calibrate the Behringer FCB1010 Expression
Pedals
Many users experience problems with the expression pedal range
on new FCB1010's, in which one or both pedals do not transmit a full range of
controller values from 0-127 (0x00-0x7F). the way to fix this is to follow the
steps outlined below.
Hope this could help if anybody else has the same problem.
Thanks for a great forum
// Björn