Connect looper pedal !

Esposito772 · July 5, 2018 at 5:14 PM

Hey guys, I'm an absolute kemper newbie so I really need your help here : I do I connect my looper pedal to my kemper profiler powerhead ? I tried to plug my guitar into the pedal and the pedal into the kemper but it didn't work at all. Did I forget to press a button or something ?

Thank you very much in advance for your response.

digbob · July 5, 2018 at 6:04 PM

the way you did this should work
but I think its better when you put this in the FX Loop of the Kemper via send and return
on the back
then you can choose the loop in one of the FX after the Amp and it will change the sound if you change it on the KPA

Esposito772 · July 5, 2018 at 7:56 PM

Thanks a lot for your answer. The way you said it should've worked is by plugging it into the main input on the profiler's front side or in the back side, into the "pedal/swtich" input ?

Andrea L · July 6, 2018 at 9:21 AM

To put looper in Fx loop, the correct wiring is:
guitar > Kemper input > Kemper send > looper input > looper output > Kemper return.

Esposito772 · July 9, 2018 at 6:14 PM

Its all good thanks folks !