Hi there,
I know this is probably a common topic, however I can't seem to find a solution after searching the forum for a while!
Ive installed the Uno4Kemper chip and powered up both the Kemper Unit and the FCB1010, however I'm not seeing the message on the Kemper recognising the pedal board, however when pushing some of the pedals certain changes or symbols appear, so I know its connected and working in some capacity. I'm looking at trying to switch between sounds on performance mode and being able to simply navigate up and down between the performances, however its so random what changes happen whenever I try and select anything using the pedal board.
Ive tried calibrating the FCB1010 and looking at the midi settings on the kemper, but I can't for the life of me think what the issue is. Im slightly disappointed as I thought the chip was supposed to be pretty straight forward! Any advice would be much appreciated!